Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Accessories for electrical actuators
Example
Set signal value 4-20 mA, not inverted, use S3L Slave
ON
OFF
S1 S2 S3 S4

9.4 Assembly

X1
Fig. 15
 Disconnect the actuator from the supply voltage.
 Take the controller board out of the packaging and check for damages.
 Plug the board vertically on plug X1 on the back side of the base board.
 During this, make sure that the board lies exactly in the lateral guides.
 For the positioner to receive the setpoint value signal: Connect the terminals of the
setpoint value input 20 to 23 or 27 to 29 for the corresponding value, see Table:
Terminal assignment. For this, use cables with a cross section of 1.5 mm
 Observe the configuration of the setpoint value, see DIP switch and switch setting.
Positioner PE25
2
.
71

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ea21Ea31Ea42

Tabla de contenido