Eliminating A Malfunction Message - Georg Fischer EA11 Manual Instrucciones

Accessories for electrical actuators Monitoring print

10.4 Eliminating a malfunction message

10
8
9
Fig. 21
In case of a malfunction message, the red LED 8 on the base board will light up. If the
monitoring print is installed, the respective LED 10 lights up red on the BCD switch, if
its set value is exceeded. On all occurring malfunction messages, the relay of the
ready-to-operate signal de-energises, i.e. there is no continuity on terminals 5, 6,
since the contact is interrupted.
 Check the cause of fault.
 If necessary, carry out relevant maintenance.
79