Setting The Dip Switch; Resetting The Cycle Counter - Georg Fischer EA11 Manual Instrucciones

Accessories for electrical actuators

13.3 Setting the DIP switch

Both switches ON:
 If a set number of cycles is reached, a malfunction is
reported, without stopping the actuator
Both switches OFF:
If a set number of cycles is reached, a malfunction is
reported, with stopping the actuator

13.4 Resetting the cycle counter

 Set the BCD switch to position 0.
 Move the actuator to the CLOSED position.
 Move the actuator back to the OPEN position.
The LED of the monitoring lights up.
 Press the reset button on the base board.
The cycle counter is set to 0.
Now, the BCD switch can again be set to the desired number of cycles, see
Table.
Cycle counter
ON
OFF
S1 S2
ON
OFF
S1 S2
85