Pratissoli LK Serie Manual De Reparación página 54

Calibrate the screws with a torque wrench as indicated in
chapter 3.
Position the spray-guard and the spray-guard spacer ring in
the seat on the piston head stem (pos. , Fig. 97 and Fig. 98).
Insert the O-ring on the two inspection covers (pos. , Fig. 99)
and assemble the covers with the use of 4+4 M6x14 screws
(pos. , Fig. 100).
Fig. 96
Fig. 97
Calibrate the screws with a torque wrench as indicated in
chapter 3 "Screw Tightening Calibration".
Mount the shaft end cover and affix it to the casing using 3 x
M8x20 screws (pos. , Fig. 101).
Calibrate the screws with a torque wrench as indicated in
chapter 3 "Screw Tightening Calibration".
Fig. 98
54
Fig. 99
Fig. 100
Fig. 101