Installation Procedures
Installation
By default, this projector is adjusted for 120-inch front projection on the
floor/desk. If you install the projector in other conditions, you have to
change some settings. Therefore, installation procedures depend on the
screen size or type, and installation method.
1 Verify the conditions of installation, such as angle of optical axis,
projection distance, height of the projector and screen.
.
2 Change the polarity according to the projection patterns.
.
3 Install the projector and screen.
.
4 Adjust the lens focus approximately.
.
5 Reset the registration data to the factory setting.
.
6 Adjust the CRT conversion angle.
.
7 Connect external video equipment.
.
The installation is completed.
Then perform the adjustments following the adjustment
procedure. (page 78
(GB)
(page 12
)
(GB)
(page 81
)
(GB)
(page 138
(page 22
)
(GB)
(page 24
)
(GB)
)
(page 20
)
(GB)
)
(GB)
5
Installation
(GB)