General Information; Purpose Of The Document; Using This Document; Intended Use - Webasto Pure II Instrucciones De Montaje

1

General information

Purpose of the document

1.1
These operating and installation instructions are part of
the product and contain information for the user to en-
sure safe operation and for the electrician to carry out
safe installation of the Webasto Pure charging station.
1.2

Using this document

Carefully read the operating and installation instruc-
u
tions before installing and starting up the Webasto
Pure.
Keep these instructions ready to hand.
u
Hand these instructions on to the following owner or
u
user of the charging station.
NOTE
We would draw your attention to the fact that, as part of
a professional installation, an installation log should be
drawn up by the installer. We also request that you fill in
our Check list for the installation of the Webasto charging
station.
NOTE
Individuals with deficiency in their colour vision require
support in the allocation of all fault indicators.

Intended use

1.3
The Webasto Pure charging station is designed for char-
ging electric vehicles in accordance with IEC 61851-1,
charge mode 3. In this charge mode, the charging station
ensures:
– The voltage is not applied before the vehicle has been
connected correctly.
– The maximum power is calibrated.
1.4

Use of symbols and highlighting

DANGER
This signal word denotes a hazard with a high degree of
risk which, if not avoided, will lead to death or serious in-
jury.
OI II Webasto Pure
WARNING
This signal word denotes a hazard with a moderate de-
gree of risk which, if not avoided, may lead to minor or
moderate injury.
NOTE
This signal word denotes a Special Technical Feature or (if
not observed) potential damage to the product.
ü Requirements for the following necessary action
u Necessary action
CAUTION
This signal word denotes a hazard with a low degree of
risk which, if not avoided, will lead to minor or moderate
injury.
1.5

Warranty and liability

Webasto shall not assume liability for defects or damage
that are the result of the installation and operating in-
structions being disregarded. This liability exclusion par-
ticularly applies for:
– Improper use.
– Repairs carried out by an electrician not contracted by
Webasto.
– Use of non-original spare parts.
– Conversion of the unit without permission from .
– Installation and commissioning by unqualified staff
(not an electrician).
– Improper disposal after decommissioning.
2

Safety

General information
2.1
The charging station has been developed, produced,
tested and documented according to the relevant safety
regulations and environmental requirements. The device
must only be used in a technically faultless condition.
Have any malfunctions that adversely affect the safety of
persons or of the device rectified immediately by an elec-
trician in accordance with nationally applicable regula-
tions.
NOTE
It is possible that the signalling in the vehicle differs from
that described here. Always read the operating instruc-
tions of the respective vehicle manufacturer and always
observe these.
2.2

General safety information

– Hazardous voltages are present within the casing.
– The charging station does not have its own main
ON/OFF switch. The protective devices installed in
the power supply system are therefore also used
to disconnect the power supply.
– Check charging station for visual damage before
use. Do not use the charging station if damaged.
– Installation, electrical connection and initial opera-
tion of the charging station must only be carried
out by an electrician.
– Do not remove the cover of the installation area
whilst in operation.
– Do not remove markings, warning symbols and
the type label from the charging station.
– The charging cable must only be replaced by an
electrician in accordance with the installation in-
structions.
– It is strictly prohibited to connect other equip-
ment/devices to the charging station.
– When not in use, store the charging cable in the
designated holder and lock the charging coupling
in the charging station. Loosely wind the charging
cable around the charging station casing so that it
does not touch the ground.
– Make sure that the charging cable and coupling
cannot be driven over, trapped and are protected
from any other hazards.
– Immediately notify Webasto Customer Service if
the charging station, charging cable or the char-
ging coupling are damaged. Do not continue us-
ing the charging station.
– Prevent the charging cable and coupling from
coming in contact with external heat sources, wa-
ter, dirt and chemicals.
EN
1