Section 2- Assembly; Assembling The Patient Lift; Unpacking The Patient Lift; Assembling The Mast To The Base - Invacare RHL450 Manual Del Operador

SECTION 2— ASSEMBLY

Assembling the Patient Lift

Use only Invacare parts in the assembly of this patient lift. The base legs, the mast,
boom, pump assembly and the swivel bar are manufactured to specifications that
assure correct alignment of all parts for safe functional operation.

Unpacking the Patient Lift

NOTE: For this procedure, refer to
FIGURE 2.1
1. Unpack the components from the
shipping carton.
NOTE: Do not remove the plastic wrap that
secures the boom to the mast in place.

Assembling the Mast to the Base

NOTE: For this procedure, refer to FIGURE 2.2 and FIGURE 2.3 on page 18.
1. If locking‐type casters are on the
patient lift, lock them.
2. Remove the shoulder bolt, nut and
washer, that secures the mast in the U‐
shape cut‐out of the base.
3. Position the mast in an upright position
and place the mast into the U‐shaped
cut‐out of the base.
4. Insert shoulder bolt with washers
through the base and mast.
5. Secure with nut.
The mast may be removed from the base for storage or transporting. Each time the
mast is removed and returned to the base, the mast MUST be properly secured to
the base assembly.
Part No 1078987
WARNING
FIGURE 2.1 Unpacking the Patient Lift
Step here to
LOCK.
FIGURE 2.2 Assembling the Mast to the
Base- Locking the Casters
WARNING
17
ASSEMBLY
DO NOT
remove plastic
wrap at this time
Step here to
UNLOCK.
Locking
Lever
Manual/Electric Portable Patient Lift