Assembling The Manual/Hydraulic Pump To The Boom - Invacare RHL450 Manual Del Operador

ASSEMBLY
Washers
Nut

Assembling the Manual/Hydraulic Pump to the Boom

NOTE: For this procedure, refer to FIGURE 2.4.
1. Remove the shoulder bolt, washer and
nut from the mounting bracket on the
boom assembly.
2. Unpack the pinch guard from the
patient lift carton.
NOTE: The bottom of the hydraulic pump
assembly will already be assembled to the mast
mounting bracket.
3. Cut the plastic‐wrap that secures the
boom and mast together.
4. Lift‐up on the boom and place it on
your left shoulder.
5. Let the hydraulic pump rest on the right‐side of your chest and rotate the shaft
extension of the hydraulic pump assembly until it lines‐up with the mounting bracket
holes in the boom assembly.
6. Turn the pinch guard 90°
7. Align the holes of the boom assembly mounting bracket with those of the hydraulic
pump and insert the bolt. Secure with washer and nut.
NOTE: Be sure that the bolt is completely through the holes of the boom assembly mounting
bracket and the manual/hydraulic pump assembly. The boom assembly will pivot easily if the
mounting hardware is aligned properly when the boom assembly is secured to the mast.
DO NOT overtighten the nut and bolt. This damages the mounting bracket.
Manual/Electric Portable Patient Lift
Shoulder
Bolt
FIGURE 2.3 Assembling the Mast to the Base
and place over the shaft extension of the hydraulic pump.
CAUTION
Shoulder
Bolt
Mounting Bracket
FIGURE 2.4 Assembling the Manual/
Hydraulic Pump to the Boom
18
Washers
Nut
Pinch Guard
NOTE: Turn 90°
Part No 1078987