Mounting The Battery Charger; Charging The Battery - Invacare RHL450 Manual Del Operador

OPERATION

Mounting the Battery Charger

NOTE: For this procedure, refer to FIGURE 3.9.
NOTE: Refer to your local regulations concerning proper mounting procedures.
1. Place the battery charger with mounting bracket on the wall at the desired position.
2. With a pencil, mark the middle hole position.
3. Measure down 6½ inches from the pencil mark and drill one mounting hole.
4. Install the bottom mounting screw until there is an approximate 1/8‐inch gap between
the screw head and the wall.
5. Install the battery charger with mounting bracket onto the bottom mounting screw.
6. Drill the remaining two mounting holes.
7. Install the two remaining mounting screws through the mounting bracket and into the
wall. Tighten securely.
8. Plug the battery charger into the wall electrical outlet.
NOTE: ON LED should illuminate.

Charging the Battery

NOTE: For this procedure, refer to FIGURE 3.10 on page 25.
NOTE: Invacare recommends the battery be recharged daily to prolong battery life.
NOTE: An audible alarm will sound (horn will beep) when battery is low.
1. Lift up on the handle on the back of the battery.
2. Lift the battery up and out away from the control box.
Make sure there is an audible click when mounting battery on the battery charger
to confirm proper mounting. Otherwise, injury or damage may occur.
3. Place the battery on the battery charger as shown in FIGURE 3.10. Make sure there is
an audible click.
Manual/Electric Portable Patient Lift
Mounting Bracket (STEP 6)
Mounting
Screws
(STEP 7)
BOTTOM Mounting Screw (STEP 4)
FIGURE 3.9 Mounting the Battery Charger
CAUTION
Battery Charger
with Mounting
Bracket (STEP 5)
24
Part No 1078987