3M Ultimate FX Manual Del Usuario página 4

OPERATING INSTRUCTIONS
Unpacking
Inspect the package contents for shipping damage and ensure all components are present (Refer to Fig. 27). The product should be inspected before
each use following the procedures in the "Inspection" section of this User Instruction.
Assembly
3M™ Cartridge 6000 Series, Filter 7093, and Cartridge/Filter 7093C Assembly (Fig. 1, 2)
1. Align the cartridge or filter notch with the small solid bayonet lug on facepiece and push together.
2. Turn cartridge or filter clockwise until it is firmly seated and cannot be further turned (about 1/4 turn).
3. Repeat with second cartridge or filter.
3M™ Filter 2000 Series (Fig. 3)
1. Align opening of filter with filter attachment on facepiece and push together.
2. Turn filter clockwise until it is firmly seated and cannot be further turned.
3. Repeat for second filter.
3M™ Filters 5N11 and 5P71
1. Place filter into 3M™ Retainer 501 so printed side of filter faces the cartridge.
2. Press cartridge into filter retainer. It should snap securely into filter retainer. When correctly installed, filter should completely cover face of cartridge
(Fig. 4).
3. To replace filter, remove retainer by lifting on tab.
In Brazil, the 3M™ Filter 5935BR can be used with the 3M™ Filter Retainer 501 on the 3M™ Full Facepiece FF-400 Series.
3M™ Adapter Assembly 502
1. Align adapter over cartridge. Engage front snap by squeezing front of cartridge and adapter together, placing thumbs of both hands over top of
adapter and fingers along bottom sides of cartridge (Fig. 5).
2. Engage back snap by squeezing back side of cartridge and adapter together using the same hand positions. An audible click should be heard as each
snap is engaged (Fig. 6).
3. Place filter onto the filter holder so that filter comes into even contact with gasket. Twist clockwise a quarter turn until it is firmly seated and filter
cannot be turned further. Repeat for second filter.
Fig. 1
3
Fig. 2
Fig. 4
(English)
Fig. 3