Cleaning And Maintenance - Amann Girrbach ceramill matik Modo De Empleo

The reference values and the information on
measures in case of exceeding or falling below the
reference values can be found on an information
sheet in the delivery scope of the Ceramill Clean-
stream.
8

Cleaning and Maintenance

Instructions on cleaning and maintenance are
shown directly on the machine display.
NOTE:
Zirconia dust is abrasive!
▷ Clean the window in the door carefully, using
only a soft cloth; do not scrub or scour.
NOTE:
Possible machine damage through dried-in cool-
ant/lubricant and bound in milling dust.
After wet processing:
▷ Clean and dry the milling chamber prior to
downtimes lasting several hours.
NOTE:
The milling chamber may only be cleaned with
water.
▷ Do not use cleaning agents.
NOTE:
The milling compartment may only be cleaned
with the specified cleaning aids (brush, cleaning
cloth)!
▷ Do not use sponges, brushes etc.
C L E A N I N G A N D M A I N T E N A N C E
NOTE:
Danger of damaging the machine!
▷ Do not use compressed air, ultrasonic or a
steam jet for the cleaning!
NOTE:
Only use the provided collet grease for lubrica-
tion of the collet cone. Do not use other types of
grease.
E N
33