Cleaning And Maintenance Of The Scanning And Milling Heads (Handpieces) - Amann Girrbach Ceramill Multi-x Instrucciones De Servicio

In no case you may modify the machine or the supplied
power cable on you own! The power supply must be operati-
vely grounded!
CaUtIOn! The manufacturer shall not assume any liability for
damage arising from improper installation.
11.1 CleanIng anD MaIntenanCe OF the
sCannIng anD MIllIng heaDs
(hanDPIeCes)
Collets and lining must be performed weekly.
Insertion / removal of the collet:
1. Switch off the milling unit at the main switch CS !
2. Remove the conus-shaped protective cap of the milling and/
or scanning head (by turning it leftwards) and unscrew the
collet using the supplied collet wrench and open-end wrench.
3. Clean the interior of the collet and the handpiece using the
supplied cleaning brush (without oil!).
4. Insert the collets again.
5. Make sure the clamping system is still open. Then mount the
supplied open-end wrench upon the axle.
6. Now tighten the clamping system using the supplied col
let wrench while applying counterpressure using the open-
end wrench. See also the training documents from the basic
course.
Upgrade kit Multi-x
O P e r at I n g I n s t r U C t I O n s
gB
45