Cleaning And Maintenance; Cleaning; Maintenance - Amann Girrbach 179560 Modo De Empleo

C L E A N I N G A N D M A I N T E N A N C E
▷ Affix upper and lower jaw with to model base at
the left and right of the All-In Bar on the univer-
E N
sal plate using modelling wax.
▪ Pay attention that the complete bottom sur-
face of the model base has contact with the
modelling wax.
▪ Bring model segments into contact with the
side surfaces of the All-In Bar, so that the
model segments are within the scan field dur-
ing the scanning process.
▪ Press the model segments with both hands
firmly against the modelling wax.
1
Fig. 30 Model with freely-positioned abutment
1 Model segment
2 Abutment
3 Modelling wax
4 All-In Bar
5 Model base
6 Universal plate
NOTE:
The model must not project out beyond the rear
limit of the universal plate (metal pins).
▷ Position the universal plate into the scanner.
▷ Scan the models.
48
2
3
7

Cleaning and Maintenance

7.1

Cleaning

The scanner must be cleaned regularly.
▷ Switch the scanner off.
NOTE:
Possible damage to the 3D sensor:
▷ Do not clean the optics of the 3D sensor in the
top of the scanner!
▷ Carefully vacuum out the interior of the scan-
ner.
▷ Wipe off the housing with a moist cloth. Do not
use aggressive cleaning agents.
4
5
7.2

Maintenance

3
6
Maintenance may be carried out only by trained,
specialized personnel.