Tunturi Pure RUN 10.0 Manual De Instrucciones página 27

▪ Do not block the ventilation openings. Keep the ventilation openings clear from
dust, dirt and other obstructions.
▪ Clean the equipment with a soft, absorbent cloth after each use.
▪ Clean the visible parts of the equipment with a vacuum cleaner with a small
suction nozzle
▪ Regularly check that all screws and nuts are tight.
Lubrication (fig. F)
The running belt must be checked for lubrication once per 2 months, based on the
average use of 60 minutes per day.
WARNING
– Before lubrication, remove the mains plug from the wall socket.
CAUTION
– Only lubricate the running belt if necessary. If you apply too much
lubricant, the running belt will slip easily due to lack of friction.
1. Stand steadily on the running belt.
2. Take hold of the front handlebar and push the running belt with your feet so that
it slides back and forth. The running belt must move smoothly and evenly without
making sound.
3. If the running belt does not move smoothly and evenly or if the running belt does
not move at all, touch the underside of the running belt with your fingertips to
check the lubrication:
– If you feel lubrication or your fingertips are shiny, there is sufficient
lubrication on the running belt.
– If you do not feel lubrication or your fingertips are dusty or rough, use a large
spoon to apply a silicon lubricant (15-20 ml) in the middle of the running
deck under the running belt and let the equipment operate at 5 km/h for at
least 5 minutes.
– After lubrication, do not fold the equipment before having done a workout for
20 minutes with a speed of at least 5 km/h. The lubricant will be spread
evenly over the running belt.
RUN 10.0
EN
27