7.1 Ch Input; Aux2 Input - Marantz SR-12S1 Manual Del Usuario

7.1 CH INPUT.

The SR-12S1 is equipped for future expansion through the use of
Multi channel Super Audio CD or DVD-Audio player.
This is selected, the input signals connected to the FL(front left),
FR(front right), CENTER, SL (surround left), SR (surround right), SBL
(surround back left) and SBR (surround back right) channels of the 7.1
CH. In jacks are output directly to the front (left and right), center,
surround (left and right) and surround back(left and right) speaker
systems as well as the pre-out jacks without passing through the
surround circuitry.
In addition, the signal input to the SW (subwoofer) jack is output to the
PRE OUT SW (subwoofer) jack.
When 7.1 CH. INPUT is selected, the last video input used remains
routed to the Monitor 1&2 Outputs.
This permits simultaneous viewing with video sources.
2.
SURROUND
TUNER F/P
STAMDBY
POEWER ON/OFF
LD DVD DSS TV
PHONES
AUX1 AUX2 7.1CH INPUT ATT
1.
Select a desired Video source to decide the routed video signal to
the Monitor 1&2 Outputs .
2.
Press the 7.1 CH-IN button or tap 7.1 input on on the remote to
switch the 7.1 channel input.
3.
If necessary to adjust the output level of each channel, use "7.1
Ch. INPUT LEVEL" in OSD menu system as desired.
Adjust the speaker output levels so that you can hear the same
sound level from each speaker at the listening position. For the
front left, front right, center, surround left, surround right, surround
back left and surround back right speakers, the output levels can
be adjusted between –10 to +10 dB.
The subwoofer can be adjusted between –15 and +10 dB.
These adjusting result will be stored to 7.1 Ch. INPUT condition.
(see to page 37)
4.
Adjust the main volume with the MAIN VOLUME knob or the VOL
buttons on the remote.
To cancel the 7.1 Ch. INPUT setting, press the 7.1 CH-IN button on
the front panel or tap 7.1 input off on the remote.
Notes:
• When the 7.1 Ch. Input is in use, you may not select a surround
mode, as the external decoder determines processing.
• In addition, there is no signal at the record outputs when the 7.1
Ch. Input is in use.

AUX2 INPUT

If you don't need to connect 7.1 Ch. input terminals with multi channel
decoder,
FL(front left) and FR(front right) inputs terminals are available as
AUX2 input.
In this case, You can connect additional audio source to AUX2 as
other audio input terminals.
SURROUND
TUNER F/P
STAMDBY
POEWER ON/OFF
LD DVD DSS TV VCR1
PHONES
AUX1 AUX2 7.1CH INPUT ATT S-DIRECT
46
AV SURROUND RECEIVER SR-12S1
DOWN
DOWN GYRO TUNING UP
AUTO TUNE T-MODE
VCR1 VCR2/DVD-R CD TAPE CD-R/MD AUX1 INPUT
DIGITAL S-VIDEO VIDEO L AUDIO R
S-DIRECT MEMO CLEAR MULTI SPKR MULTI ROOM
AV SURROUND RECEIVER SR-12S1
DOWN
DOWN GYRO TUNING UP
AUTO TUNE T-MODE
VCR2/DVD-R CD TAPE CD-R/MD AUX1 INPUT
DIGITAL S-VIDEO VIDEO L AUDIO R
MEMO CLEAR MULTI SPKR MULTI ROOM