Installation; Nstallation - Cebora 208-10 Manual De Istrucciones

CEBORA S.p.A.
2

INSTALLATION.

The equipment must be installed by skilled personnel.
All connections must be made in full compliance with current safety laws.
2.1 Installation.
The Control Panel does not operate independently, but must be connected to the Power Source, with
which it communicates and from which it receives its power supply.
NOTE: The Control Panel art. 208.10 can be used in systems based on Power Sources art. 287.80
beginning from firmware release 09, and Power Sources art. 289.80 beginning from firmware
release 16. The Power Sources with lower firmware release must be updated by means the
appropriate programming procedure previewed in the Cebora internet site www.cebora.it.
Connect the Control Panel (24) to the Power Source (21) by means of the connection cable (1) (fig. 3).
Place the Robot Interface (25) inside the Robot Control Cabinet (5), following the instructions given in
the Robot Interface Instruction Manual.
Complete the remaining connections of the other Welding System equipments, consulting the
corresponding Instruction Manuals at par. "Installation".
Power up the Welding System using the BU switch of the Power Source.
The System is powered; on Control Panel led J flashes rapidly.
After one second, all displays and leds are lit (lamp test).
After one second, display O reads "Art" and display P shows the code of the Power Source to which the
Control Panel is connected (e.g.: "287").
Subsequently display O indicates "MSt" and display P shows the version of the program inserted in the
Master control of the Power Source (e.g.: "09").
Subsequently display O indicates "PAn" and display P shows the version of the program inserted in the
Control Panel (e.g.: "01").
Subsequently display O indicates "Mot" and display P shows the version of the program inserted in the
Motor control of the Wire Feeder Unit (e.g.: "09").
Thereafter, the Control Panel returns to the condition it was before the last shutdown.
One second after shutting on the BU switch, the fan on the Power Source operates for 10 seconds, then
stops.
Based on its setting the Cooling Unit may start running (par. 7.1).
3.300.189-B
25
GB
04/03/2016