Nching Time Out To ); High Frequency Unit (Hfu) - Cebora 208-10 Manual De Istrucciones

CEBORA S.p.A.
Make sure that the arc length in welding is the same for both currents; if necessary, turn the knob Q to
correct it (see "Examples of current profiles in Robot applications", at the end of the present manual).
NOTE: Welding tests may be conducted within the "Double Pulse" function.
GB
NOTE: Should it be necessary to adjust the arc length of the lowest current, lowest speed, adjust the arc
length of the reference speed. When the reference speed moves, the previous settings must also be
repeated for the new speed.
Press briefly the key E to exit the "Second Functions" menù, saving all current settings automatically.
7.12 Inching time out (Ito).
Available starting with the firmware in release 4 for art. 287 and 06.09.10.10 for art. 289.
If active, it blocks the Power Source if, after the start (Arc-On), the wire comes out longer than the length
assigned to the function (max. 50 cm) without any output current.
Press for a time longer than 3 seconds the key E to enter the "Second Functions" menù.
Use knob N to select Ito on display O; use knob Q to select the function status or value, visible on
display P:
 OFF = not active (default);

1-50 = function value.
Press briefly the key E to exit the "Second Functions" menù, saving all current settings automatically.

7.13 High Frequency Unit (HFU).

Allows to enable the eventual external High Frequency Unit.
In Robot applications, that is with "Robot" function active, is not available.
Press for a time longer than 3 seconds the key E to enter the "Second Functions" menù.
Use knob N to select HFU on display O; use knob Q to select the type of operation to carry out, visible
on display P:

OFF = not active (default);
 On = active.
Press briefly the key E to exit the "Second Functions" menù, saving all current settings automatically.
3.300.189-B
fig. 7
42
04/03/2016