Saving A Job; Deleting A Job; Changing A Job (Recall Function) - Cebora 208-10 Manual De Istrucciones

CEBORA S.p.A.
6.4

Saving a Job.

A Job cannot be saved from the Robot Terminal but just from the Control Panel.
From the Robot Terminal, select the Parameter Selection Internal mode, to make the Control Panel
operative.
After performing a welding test with the parameters that you intend to save, press the AZ key, for a time
longer than 3 seconds, to activate the "Job" function (led M lit).
Display O shows Sto and display P flashes the first free "Job number".
Use knob Q to choose the desired "Job number" (if it is already occupied, the message on the display P
becomes steady).
Hold down the AZ key for a time longer than 3 seconds, to save the Job selected; an acoustic signal
(beep) signals that the Job has been saved.
When the Job has been accepted, the Control Panel exits the "Job" function (led M off) and returns to
normal operations.
To exit the "Job" function without to save any programs, briefly press the AZ key; the led M shuts off
and the Control Panel returns to normal operations.
6.5

Deleting a Job.

A Job cannot be changed from the Robot Terminal but just from the Control Panel.
From the Robot Terminal, select the Parameter Selection Internal mode to make the Control Panel
operative.
Press the AZ key, for a time longer than 3 seconds, to activate the "Job" function (led M lit).
Display O shows Sto and display P flashes the first free "Job number".
Use knob Q choose the "Job number" that you intend to delete (the message on display P becomes
steady, to indicate the number of an existing Job).
Use knob N to choose the abbreviation dEL, on display O.
Hold down the AZ key for a time longer than 3 seconds; an acoustic signal (beep) signals deletion of the
Job; the message on display P begins to flash (free "Job number").
To exit the "Job" function without deleting any programs, briefly press the AZ key; the led M shuts off
and the Control Panel returns to normal operations.
6.6

Changing a Job (recall function).

A Job cannot be changed from the Robot Terminal but just from the Control Panel.
From the Robot Terminal, select the Parameter Selection Internal mode, to make the Control Panel
operative.
Press the AZ key, for a time longer than 3 seconds, to activate the "Job" function (led M lit).
Display O shows Sto and display P flashes the first free "Job number".
Use knob Q to choose the "Job number" that you intend to change (the message on display P becomes
steady, to indicate the number of an existing Job).
Use knob N to choose the abbreviation rCL, on display O.
Hold down the AZ key for a time longer than 3 seconds; an acoustic signal (beep) signals acceptance of
the Job. When the Job has been accepted, the Control Panel exits the "Job" function (led M off) and
returns to normal operations.
From the Control Panel it is now possible to change the parameters of the selected Job.
To exit the "Job" function without calling up any Job, briefly press the AZ key; the led M shuts off and
the Control Panel returns to normal operations.
Once the parameters have been changed and the welding done, the new Job may be saved using the
saving procedure in par. 6.4.
3.300.189-B
37
GB
04/03/2016