Service And Maintenance - IKAR HRA Instrucciones De Uso

GB
14. Fall arrest blocks must not be used for securing persons working above bulk goods or
similar substances where people can sink in (Fig. 9).
15. As necessary, but at least every 12 months, fall arrest blocks with recovery
mechanism must be inspected by the manufacturer or by persons trained and
authorised by the manufacturer (Fig. 10). This must be documented in the inspection
log book supplied with the product. The effectiveness and durability of the fall arrest
block depends on regular inspection.
16. Observe BGR 198 (fall and BGR 199 (rescue operation)).
17. With the fall arrest block above the user, the clear height below the user must be 2.4
m.
18. The IKAR fall arrest block with recovery mechanism can be used in a temperature
range from -30° C to +50° C in accordance with EN 360 (Fig. 12).
19. The rated load is 136 kg (Fig. 13).
20. Fall arrest blocks with recovery mechanisms must be protected from the effects of
welding flames and sparks, fire, acids, lyes, solvents and similar agents.
21. No modifications may be made on the device.
22. Note: Fall arrest blocks with recovery mechanism may only be used by persons who
are appropriately trained or otherwise skilled. Users must be free from health
impairments (alcohol, drug, medication or cardiovascular problems).
23. The service life of the fall arrest block with recovery mechanism must be determined
in the yearly inspection; it is approx. 10 years depending on load stress.
24. After every use of the fall arrest block, the device must be inspected by an expert
trained by the manufacturer.
25. When the HRA fall arrest block is used, it must be ensured that the loaded lifeline
does not pass over edges.

Service and maintenance

1. The lifeline shall only retract under load. On no account may the lifeline be fully pulled
out and released because the karabiner hook jolting against the device may cause
the retraction spring to break.
2. For devices that are constantly exposed to the weather, it is recommended to grease
the steel rope with acid-free oils or Vaseline at regular intervals.
3. IKAR fall arrest blocks with recovery mechanism should be stored in dry, dust- and
oilfree condition in a suitable container.
4. Components which have become wet during cleaning or use may only be dried
naturally, not near a fire or similar heat sources.
Labelling of the fall arrest block with recovery mechanism
from HRA 24:
Rope length
Supervising body
Consecutive serial number
Illus. 14
Type designation
Type: HRA XX
Fall Arrest Block with recovery mechanism
Lifeline length/type / longueur de câble/ type:
XXX cable/câble XXX: XXm x Ø 4.8mm
Rated capacity / capacité nominale: 136kg
EN 360:2002/1496:2007 B
max. arrest distance / distance d'arrêt: < 1.4m
nur für Rettungszwecke geeignet
arrest force / arrêter de force < 6kN
for rescue purposes only
Serial No / Numéro de série: 1234567
uniquement à des fins de sauvetage
Manufacturing / Fabrication Date: XX-20XX
WARNING: Follow all manufacturers instructions included at the time of shipping.
AVERTISSEMENT: Respectez les instructions du fabricant incluses au moment de l'expédition.
2,4 m
min.
7.9 ft
Product
nächste Revision
next revision
prochaine révision
EN 360:2002 / 1496:2007
, Z359.14-2012
Standard
max.
136 kg
300 lbs
Manufacturer
10
HRA XX = galv. Steel Cable
HRA XX D = Dyneemacable
HRA XX E = Stainlesssteel cable
Next revision
Nominal lifting capacity
Read the instruction manual
Date of manufacture
10
11
2,4 m
min.
7,9 ft
12
13
max.
136 kg/
300 lbs