Final Installation - Harbor Breeze E-CM54RBZ5CRCI Manual Del Usuario

WIRING FOR REMOTE CONTROL AND FAN (continued from previous page)
1. Make the necessary wiring connections for remote operation
according to Fig. 1. For each wire connection, use one of the
wire connectors (Q) provided, making sure to screw wire
connector (Q) on in a clockwise direction. [Make sure to
connect all GROUND (GREEN) wires together from fan (on
downrod and mounting bracket) to BARE/GREEN wire from
ceiling.]
WIRING TIP: Wiring your fan's remote control requires extreme
patience. Take mandatory breaks while wiring to allow your
arms to rest.
2. Tape wire connectors (Q) and wires together with electrical
tape. [Fig. 2]
Warning: Make sure no bare wire or wire strands are
visible after making connections. Place green and white
connections on opposite side of box from the black, orange and
blue (if applicable) connections.
3. Gently slide remote control receiver (V), flat side up, into
mounting bracket (C). Turn spliced/taped wires upward and
gently push wires and wire connectors (Q) into outlet box. Let
antenna from receiver (V) hang to the side. [Fig. 3]
Note: The remote control included with this fan meets the
following requirements:
a. Not for use with solid state fans.
b. Electrical rating: 120V / 60 Hz; motor amps:1.0 MAX.;
light watts: 300 (incandescent only).
FINAL INSTALLATION (continued on next page)
1. Locate two canopy mounting screws (S) on underside of
mounting bracket (C) and remove screw (S) closest to the open
end of of the hanging bracket (C). Partially loosen the other
screw (S). Lift canopy (B) to mounting bracket (C). Place
rounded part of slotted hole in canopy (B) over loosened screw
(S) in hanging bracket (C) and push up. Twist canopy (B) to
lock. Re-insert screw (S) that was removed, and then tighten
both screws (S) securely. Slide canopy cover (X) up to canopy
(B), aligning rounded part of slotted holes in canopy cover (X)
with screwheads in bottom of canopy (B). Turn canopy cover
(X) to the right (clockwise) until it stops. [Fig. 1]
white supply wire
black supply wire
blue
white
black
from fan
from receiver
black
white
orange
blue
Fig. 1
Fig. 2
Antenna
Fig. 3
A
Fig. 1
7
ground
(green or bare)
ground (green
or bare)
black
from ceiling
from receiver
black
AC IN L
white
AC IN N
V
antenna
Q
Q
Q
C
A
V
B
S
X
white