Utilization - IKOS ECOpellets Insert Manual Del Usuario

Replenishment of pellets
EN
Insert with refill per load drawer
This charging system can be used with the equipment in operation, but always with care as
you will be close to sources of heat.
To refill the tank, open the cargo drawer by pulling the upper grate completely. Pour the pellets
into the drawer and with the aid of the accessory the pellets should be pushed to the back of the
drawer. The pellets will fall into the tank. When the pellets stop falling and begin to accumulate
in the drawer stop loading.
The tank has a maximum capacity of about 15 kg (depending on its size and density).
Activation
Before operating the unit, please make sure that the pellet feeder channel is filled with pellets.
To do this, with the unit turned off enable the pellet feeder function. The unit will be ready for
operation when the first pellets start to fall into the burner. Disable the function.
To start operating the unit you need to press the start/stop key for 3 seconds. The display will
show the message "Check Up" during the lighting phase until completion.
The pellets travel through the pellet feeder channel onto the burning basket (combustion
chamber), where they will be ignited by means of a heat resistor. This process may take between
5 to 10 minutes, depending on whether the worm screw has been previously loaded with pellets
or not. Upon completion of the ignition phase, "Normal" should appear on the display.
The heating power can be adjusted at any time by accessing the "Combustion Management"
menu in the "Menu Personalisation" menu.
You can choose between five pre-set power levels. The selected power is indicated on the
display. The initial power setting at each start-up will correspond to the power level set during
the last cycle operation.
The unit will be hot during operation, so you should be careful when touching the glass, the
door lock and the heat exchanger damper.
The insert should always be disabling by the same method that was active. During the
activation process, the equipment must never be disconnected.
USE
EN // 100
USER'S MANUAL