IKOS ECOpellets Insert Manual Del Usuario página 99

Installing the frame
Before installing the frame, it must be immediately verified that the packaging is complete and
in perfect condition, any damage or lack of components must be reported before installation.
EN
After having removed the package, make sure that the contents are intact and complete. If the
contents of the package do not correspond to those indicated above, contact the retailer from
whom you purchased the appliance.
On this equipment it is possible to install different finishing frames.
To install the frame, you must first check that the frame is compatible with the insert.
Reference Model frame Dimension (mm)
5605666759801 Aro 4L 44 mm 773 x 684
With the insert installed and the frame prepared, the next step is to connect the two.
First the insertable must be removed about 250 mm to be able to work.
On the sides of the equipment there are 2 screws (DIN 967 M4x8mm) the same should be
loosened about 3 mm.
Install the frame so that the screws of the insert match the openings in the frame.
Press the frame to the bottom and point the screws not tightening to the end position.
Place the insert in its final position by closing the safety locks and check the position of the
frame in relation to the wall making sure that they are perfectly parallel.
If the wall is sensitive, colour, or material, it is advisable to leave the frame between 1 and 2 mm.
Re-open the safety latches, remove the insert and tighten the screws to the end position.
EN // 99
USER'S MANUAL