IKOS ECOpellets Insert Manual Del Usuario página 113

To remove the baffles, you first have to remove 2 M6x20 DIN 912 screws as shown.
First remove the bottom plate as shown below by turning the plate slightly and removing it
through the right-side cover.
To complete the maintenance task, repeat the reverse process by placing all parts back in place.
EN
Do not forget to close the safety locks.
NOTE: The frequency of maintenance tasks depends on the quality of the pellets.
Review after a long period of inactivity
Check that the gas outlet or combustion air inlet is not obstructed by elements outside the
installation, e.g. nests, or by any type of infiltration.
End of life
Around 90% of the materials used in the manufacture of these units is recyclable, thus helping to
reduce environmental impact and contributing to the sustainable development of the planet.
End-of-life units should be taken to licensed waste operators. We advise you to contact your
local council for collection.
EN // 113
USER'S MANUAL