IKOS ECOpellets Insert Manual Del Usuario página 94

supervision or after receiving proper training. Cleaning and maintenance intended for the end
user must not be carried out by children without supervision (EN 60335-1).
Do not touch the pellet insert when barefoot or if any part of your body is wet or humid.
Do not tamper with the safety devices or adjustment features without the manufacturer's
EN
authorization.
Use only the replacement parts recommended by IKOS.
It is prohibited to cover or reduce the size of the ventilation openings of the installation.
The pellet insert is an equipment that requires air to have a proper combustion, the possible
airtightness of the place where the equipment is located or the existence of other sources of
air extraction in the house can prevent the correct functioning of the equipment.
The existence of vents is a requirement for proper combustion.
Please keep the packing materials away from children.
During normal operation, do not open the door of the unit; You must always work in the closed
position and with the safety latches locked.
Some parts may overheat during normal operation, so the direct contact with hot parts such
as the door handle and glass should be avoided.
Check for the existence of any obstructions to the fume duct before turning on the unit after a
long idle period.
The pellet insert is designed to work inside a protected environment. Safety systems may be
used to turn off the insert. If this happens, contact the after-sales service and never in any
situation disarm the safety systems.
The pellet insert must not be installed in very small rooms or in explosive atmospheres.
The pellet insert is a biomass heating unit equipped with an electric fume extractor. The
occurrence of a power failure during its use may prevent the fume to be extracted, consequently
causing the room to be filled with smoke. For this reason, a natural fume extraction system,
like a chimney, is recommended.
Never turn off an operating Free-Standing Pellet Fire unit by disconnecting the electric plug.
The fume extractor on the Free-Standing Pellet Fire unit is a powered feature, so disconnecting
the power plug will prevent the extraction of combustion fumes.
The unit must be disconnected from the mains power before any maintenance procedures can
be performed. Please allow the unit to cool down completely before any maintenance operation
(if operating before).
EN // 94
USER'S MANUAL