Package content
The packaging of the equipment has the following contents:
•
ECOpellets insert
•
Handle for opening the door and extracting the equipment
•
Power cable
•
Infrared remote control
•
Handle for inserting the pellet
•
Manual
Before unpacking the unit, check if the package is in perfect conditions, and report to the
installer or reseller if the package evidences signs of damage or defect.
After unpacking the unit, please check if the contents are complete and undamaged. If not,
please contact the reseller where the unit was purchased.
Unpacking the insert
To unpack the equipment, you must first remove the retractable bag that surrounds the carton
box. Then remove the box by lifting it up and removing the bag wrapping the insert and the
Styrofoam plates.
The insert has a fixed part and a movable part which can be separated. To separate the two
parts, first open the two safety latches under the door, use the accessory to make it easier to
open.
With the two latches open, use them as pullers to separate the movable part from the fixed
part attached to the pallet.
The surfaces on which the parts are supported must be protected.
With the help of a star wrench PZ2 remove the two screws securing the fixed part to the
pallet, the equipment is thus completely unpacked.
When you open the runner system to the limit, you notice a ledge that locks the moving
part, as the ledge passes, the slides are released and the equipment may fall. You have
to be careful that this does not occur. The movable part of the fixed part is then separated.
Safety precautions
Make sure you fully read and understand the instructions contained in this manual before using
the pellet insert as a biomass heating unit.
The pellet insert is not intended for use by children or people physically and/or mentally
challenged, or that are inexperienced or unfamiliar with using the unit, except when under
EN // 93
USER'S MANUAL
EN