IKOS ECOpellets Insert Manual Del Usuario página 101

Disabling
The turn off sequence is performed by pressing the start/stop key for 3 seconds.
Until completion of this phase the display will show the message "Disable". The extractor will
EN
remain active until a fume temperature of 40°C minus the delta of 2 °C is reached, to ensure
that all the fuel is completely burned.
Recommendations on using this unit
Ensure that the unit is properly connected to the power mains using the 230V AC power cable.
Check if the pellet reservoir is supplied with pellets. Inside the pellet reservoir is a safety grid
to prevent users from reaching the worm screw.
Always check if the burner is not obstructed before igniting the unit.
The unit's combustion chamber is made of iron plate coated with high temperature resistant
paint, which releases fumes during the first burning sessions due to the curing of the paint.
Please make sure the room where the unit is installed has adequate air circulation; otherwise, the
unit will not work properly. For this reason, you should consider if there are other air consuming
heating appliances in the room (e.g. gas units, braziers, extractors, etc.) as these should not
be used simultaneously with this unit.
You should not turn the stove off and on intermittently, as this could damage the unit's electronic
and electric components.
Even though the unit is grounded, do not touch the unit with wet hands; the improper handling of
the unit may cause an electric discharge. If you notice any electrical problems, please contact
the person who performed the installation.
The unit should only be disconnected after its full stop. Make sure that the display shows "off"
before disconnecting the unit. If necessary, unplug the power cable from the power socket.
Never open the door when the unit is still connected to the power socket or during its operation.
If you need to open the door, disconnect the unit and allow it to cool down completely.
The units have a probe to measure the room temperature. This probe is attached to the grid
at the rear panel. For a good reading of the room temperature, avoid the contact between the
end of the probe and the unit chassis. If you want, you may secure the probe to the wall near
the unit.
Before starting up the unit, check to determine if the deflector plate is correctly positioned.
EN // 101
USER'S MANUAL