IKOS ECOpellets Insert Manual Del Usuario página 98

You should select the type of configuration that best suits your needs and use the proper tools
and security measures for the installation.
To assemble the table components, you need a 6 mm hex key.
The components that make up the table are as follows:
EN
Protect the surface on which you are going to work. The four legs of the table should be attached
by hand with four DIN 912 M8x20mm screws. The rest of the assembly will be easier to perform.
Place one of the short locks on the inside of one of the leg extensions and insert between the
two leg extensions on one side, as can be seen in the image below. Place one of the long
interlocks on the outside and secure the assembly with a DIN 912 M8x20mm bolt. Do not tighten
the bolt tightly to make the rest of the assembly easier. The leg extensions have 5 holes, you
must select which to apply as well as the total height of the table.
One must repeat the process for the other three legs.
Place the two set-squares through the opening on the table and put a screw and washer in
each. Do not tighten the bolts completely, just enough to allow displacement of the brackets.
To place the auxiliary table in its final position, remember that the table has to be installed
62,5mm from the front wall. Then mark the four holes of the legs on the floor, drill the holes, you
must use the necessary means of fixing as indicated previously. At the end the table should
be fixed to the floor.
You should level the table as accurately as possible with the help of a level. Tighten all screws
with a 6mm umbrako wrench. Move the squares on the back wall and mark the holes. Remove
the brackets, if necessary, remove the screws and remove the assembly to make it easier to
drill holes in the wall. Once the necessary fixing means have been made and placed, place
the brackets back in position. Check that the table is level and that it respects the height of
62,5 millimetres. The screws that secure the table brackets must be tightened with a 6 mm
umbrako table.
Before finishing installation check if the table is leveled.
Description
Screw DIN 912 M8x20mm
Washers DIN 9021 M8
Extension for leg
Table leg
Long locking
Short locking
Table
Fixing brackets
EN // 98
USER'S MANUAL
Quantity
19
4
4
4
2
2
1
2