Applications; Ordinary Maintenance - Sol Welding QUAD Serie Manual De Instrucciones

Instruction Manual
4-5) MIG / MAG, Pulse MIG or Twin Pulse MIG (optional)
These applications can be achieved by connecting to the wire fee-
der to the generator see Table 1.1. (See Chap. 5 COMPOSITION
SYSTEM to page 5).
In this case is sufficient to select the type of welding on the front
panel of the generator and the system will set up automatically the
correct program.
Based on selectable Standard function (STD), Synergy (SYN) and
Pulse MIG (Pulse MIG), it allows to obtain a better welding quality
with an extreme setting simplicity from the user thanks to the 700
internal programs.
Thanks to a very simple system, all the regulations are available on
the front panel of the wire feeder.
6) ELECTRODE (Cellulose "E6010")
In Stick mode, machine allows the welding of whichever type of
electrode, including the cellulose electrode "E6010". It is also pos-
sible to regulate the machine with dynamic transfer personalised
settings.

APPLICATIONS

I
n MIG/MAG applications, the interconnecting cable can be up to
50 Mt. Long. For different lengths please get in touch with our ser-
vice centre.
• Cooling unit pump prevalence of is of max 7 Mt.
• Any different application from the listed ones is not permit-
ted and can compromise the work safety and the reliability of
the system.
In case the installation has to be carried out in particular hostile
conditions, please refer to the service centre for help, advises and
use precautions. It is advisable to keep up an ordinary maintenan-
ce procedure, (to be agreed with the service centre) every 2-3
month after the sale of the generator.

ORDINARY MAINTENANCE

Avoid any deposit of metallic dust inside the generator.
Disconnect the generator from the net, before operating any
servicing!
Standard checks to the generator:
• Operate an internal cleaning by using low pressure
compressed air and soft bristle brushes.
• Check the electrical connections and all the rest of
the connecting cables.
For the maintenance and the use of gas regulators consult the
specific handbook.
Warning! When working with the cooling unit,
it should exclusively be used the coolant sup-
plied by Sol Welding.
QUAD AC/DC SERIES
GB
3 GB