Sol Welding QUAD Serie Manual De Instrucciones página 74

Instruction Manual
A) SEARCHING THE PROGRAMME NUMBER
P R O G : 3 0 4 S Y N
M a t : a l S i 5
G a s : H e
W i r e m m : 1 . 6
NOTE: within the same programme, it is possible to select the type
of work (STD, SYN, PULS) by rotating the knob (41).
The LCD display (43) shows firstly, the description of the pro-
gramme with MIN and MAX current. Then, it shows the information
on material, gas and wire diameter. The programme number is
memorized if a welding is carried out.
GB
32
1. Once the programme
number to be used is
given, for instance pro-
gramme 304, press the
push-button (49). The
LED (48) flickers.
2. On the LCD display
(43) select the pro-
gramme line number
using the push-button
(49).
3. Select the programme
number using the knob
(41).
B) SELECTION THROUGH SEARCHING THE PROGRAMME
P R O G : 3 0 4 S Y N
M a t : a l S i 5
G a s : H e
W i r e m m : 1 . 6
P R O G : 3 0 4 S Y N
M a t : a l S i 5
G a s : H e
W i r e m m : 1 . 6
P R O G : 3 0 4 S Y N
M a t : a l S i 5
G a s : H e
W i r e m m : 1 . 6
By now the searched programme number appears on the top line
PRG.
NOTE: within the same programme, it is possible to select the type
of work (STD, SYN, PULS) by rotating the knob (41). The programme
number is memorized if a welding is carried out.
QUAD AC/DC SERIES
1. Select the line MAT on
the LCD display (43)
using pressing the switch
(49). The LED (48)
flickers.
2. Select the feeler mate-
rial with the knob (41).
3. Select the type of gas
on the line GAS.
4. Select the wire diame-
ter on the WIRE mm line.