Welding Mode Electrode; Cold Wire Feeder System - Sol Welding QUAD Serie Manual De Instrucciones

Instruction Manual
11.
COLD WIRE SYSTEM.
NOTE: numbers shown below are referring to Fig. 3 of chapter 6
COMMANDS DESCRIPTION (page 9).
If AUTO STD, AUTO PULSE or AUTO MIX is selected, the quanti-
ty of Cold Wire that is given during welding, is in full synergy with
the chosen welding program (material, tungsten and wire) and with
the welding current.
1. Select COLD WIRE
FEEDER mode, refer to Par.
10.4 to page 20.
Selection of the Cold Wire
system is done by pressing
on push button (31), this but-
ton has to be pressed few
times until Led (35) lights up.
2. Digital display (36) shows
the speed of the Cold Wire
referred to the set speed on
the machine.
For example: here below is shown how to modify the Cold Wire
feeding speed.
C o l d W i r e
S i n e r g i c : 2 . 2
Yo u r : 2 . 6 ( + 1 8 % )
QUAD AC/DC SERIES
A. Set the correct welding
current for the base material
to be welded (Thickness and
welding mode).
B. Select the Cold Wire
feeding mode. Right hand
side digital display (36) will
show the set wire speed in
reference to the set current.
C. Set the new correction to
the Cold Wire speed and
verify it during welding.
D. Digital display (43) shows
an indication of the synergy
curve modification between
the set current and the cold
wire feeding speed.
27 GB
GB