Selection Of The Torch Switch Cycle And - Sol Welding QUAD Serie Manual De Instrucciones

Instruction Manual

10.4 Selection of the TORCH SWITCH CYCLE and

ELECTRODE welding mode
GB
20
1. The torch switch cycles
are indicated by the Led (44-
45-46-47) and are following:
2 Times torch
switch cycle
4 Times torch
switch cycle
Slope cycles
Timer cycle
2. Press push-button (50)
and select the desired cycle.
NOTE: when the Led
is ON at once with the Led
means that the
selected welding
cycle has also an up and a
down slope.
QUAD AC/DC SERIES
3. COLD WIRE CYCLE.
Press push-button (42) until
function is
selected and it
can be set trough points 1
and 2..
NOTE: selection of TIG AC
or TIG DC function
is given from the welding
program.
4. To select ELECTRODE
mode, press push-button
(42) until the Led lights up: