Connecting Control Cords; About Sr - Pioneer PDP-5050HD Manual De Instrucciones

Enjoying through External Equipment

Connecting control cords

Connect control cords between the Media Receiver and other
PIONEER equipment having the
the connected equipment by sending commands from its
remote control unit to the remote control sensor on the Media
Receiver.
After the CONTROL IN terminals have been connected, the
remote control sensors on the connected equipment do not
accept commands from the remote control units. Face the
remote control units to the remote control sensor on the
Plasma Display when operating the connected equipment.
• Make sure that the power is turned off when making connections.
• Complete all component connections before making control cord
connections.

About SR+

The CONTROL OUT terminal on the rear of the Media Receiver
supports SR+ that allows linked operations with a PIONEER
AV receiver. SR+ presents functions such as the input switch
linkage operation function and the DSP surround mode display
function. For more information, see the instruction manual that
came with the PIONEER AV receiver supporting SR+.
• While in connection through SR+, the volume on this system is
temporarily minimized.
logo. You can then operate
Media Receiver (rear view)
I N OUT
VCR CONTROL
ANTENNA/ Cable Cable
CONTROL
CABLE A IN CARD CARD
IN
ANTENNA B
S-VIDEO INPUT 2
VIDEO R-AUDIO-L
SERVICE ONLY
OUT
MONITOR OUT S-VIDEO VIDEO R-AUDIO-L
I N OUT
CONTROL
The control cables (commercially available) are mono sound
cables with mini plugs (no resistance).
DIGITAL OUT
OPTICAL
S400
(TS)
INPUT 1 COMPONENT VIDEO
VIDEO
R-AUDIO-L Y C B /P B C R /P R
INPUT 1 INPUT 3
R-AUDIO-L Y C /P C /P HDMI
S-VIDEO INPUT 3 B B R R
INPUT 3
CONTROL
IN
OUT
CONTROL
IN
OUT
CONTROL
IN
OUT
12
61
En