No Operation Off (Av Mode Only); Power Management (Pc Mode Only); Adjusting Image Positions (Av Mode Only); No Operation Off - Pioneer PDP-5050HD Manual De Instrucciones

10 Adjustments and Settings

No Operation off (AV mode only)

The system will be automatically placed into the standby mode
when no operation is performed for three hours.
1
Press HOME MENU.
2
Select "Power Control". ( /
3
Select "No Operation off". ( /
4
Select "Enable". ( /
Item Description
Disable Does not place the system into the
(factory default) standby mode.
Enable Places the system into the standby mode if
no operation is performed for three hours.
5
Press HOME MENU to exit the menu.
• Five minutes before the system is placed into the standby mode, a
message appears every minute.

Power Management (PC mode only)

The system will be automatically placed into the standby mode
when no signal is received from the personal computer.
1
Press HOME MENU.
2
Select "Power Control". ( /
3
Select "Power Management". ( /
4
Select "Mode1" or "Mode2". ( /
Item Description
Off No power management
(factory default)
Mode1 • Places the system into the standby mode
• Even when you start using the computer
• The system is switched on again by
Mode2 • Places the system into the standby mode
• When you start using the computer and a
• The system is switched on again by
5
Press HOME MENU to exit the menu.
44
En
then ENTER)
then ENTER)
then ENTER)
then ENTER)
then ENTER)
then ENTER)
when no signal is received from the
personal computer for eight minutes.
and a signal is received again, the system
stays off.
pressing STANDBY/ON on the Plasma
Display or TV on the remote control
unit.
when no signal is received for eight
seconds.
signal is received again, the system is
switched on.
pressing STANDBY/ON on the Plasma
Display or TV on the remote control
unit.
Adjusting image positions
(AV mode only)
Adjust the horizontal and vertical positions of images on the
Plasma Display.
1
Press HOME MENU.
2
Select "Option". ( / then ENTER)
3
Select "Position". ( / then ENTER)
4
Select "H/V Position Adjust". ( /
Position
H/V Position Adjust
Reset
5
Adjust the vertical position ( / ) or horizontal position
( / ).
6
Press HOME MENU to exit the menu.
• To restore the factory defaults for all the items, press
"Reset" in step 4, and then press ENTER. A confirmation screen
appears. Press / to select "Yes", and then press ENTER.
• Adjustments are stored separately according to input source.
then ENTER)
/ to select