Identification Number - Roger Technology CTRL/P Instrucciones Y Advertencias Para El Instalador

Directional mode 2. When entering, the barrier is opened with an AP open command, and closes after the
automatic closing time set with parameter
mended to set parameter
When leaving the parking area, the barrier is opened by a PED command received from the magnetic loop.
Once the vehicle has crossed the barrier and released contact FT (NC), the barrier closes.
NOTE: it is possible to add further 5 s delay before closing, setting
Enable close command after activation of photocell (FT)
N.B.: this parameter is not visible if the value of parameter
Disabled.
Enabled. The barrier stops if the photocell is activated during closing manoeuvre. The barrier resumes
closing when the photocell is cleared.
Selection of the battery operation management
Setting a value different than
be selected via parameter
The control unit always accepts commands until the battery is completely exhausted.
The command becomes active when the battery voltage drops to the minimum threshold (22Vdc for battery
2x12Vdc)
The command becomes active when the battery voltage drops to the medium threshold (23Vdc for battery
2x12Vdc)
The command becomes active when the battery voltage drops to the maximum threshold (24Vdc for battery
2x12Vdc)
Selecting the battery operation limitations.
N.B.: the parameter is visible only if par.
There is no limitation for the commands when the battery voltage drops under the selected threshold. An
error alert may be activated via the SC output (if parameters
When the battery voltage drops under the threshold selected with par.
opening commands and does not perform closing.
When the battery voltage drops under the threshold selected with par.
control unit automatically opens the barrier's boom and accepts only a closing command.
It accepts only closing commands even if the ORO input is active and if the parameter is
Selection of the battery type and consumption reduction
NOTE: An INCORRECT setting of this parameter, when there is no mains voltage, blocks the functions and
the display shows the message
Battery 24Vdc (2x12V). Acceleration/deceleration/speed reduction enabled, to increase the battery life.
24dc battery (2x12Vdc). No reduction in performance, maximum battery consumption.
Battery 36Vdc (3x12V). Acceleration/deceleration/speed reduction enabled, to increase the battery life. - DO
NOT SELECT. FUTURE USE -
Battery 36Vdc (3x12V). No performance reduction, maximum battery consumption. - DO NOT SELECT.
FUTURE USE -
Restoring factory default values
NOTE This procedure is only possible is NO data protection password is set.
• Turn off the power.
• Press and hold the + (PLUS) and - (MINUS) buttons until the unit switches on.
• The message
• The default factory settings have now been restored.
Identification number
The identification number consists of the values of the parameters from
N.B.: The values shown in the table are indicative only.
72
. NOTE: in order to have the automatic closing, it is recom-
different to .
a battery voltage level check is activated. The desired operation type can
and an error alert can be activated through the SC output via parameter
is different than
(if set to
+
P1
P2
-
x4 s
flashes on the display after 4 s.
.
= .
and are adequately set).
, the control unit accepts only
, after a 5 s pre-flashing, the
or and the battery is 2x12Vdc) or an error alert
Warning! Restoring default settings cancels all
settings made previously except for parameter
after restore, check that all parameters are suitable for
the installation.
The default factory settings may also be restored using
the + (PLUS) and/or - (MINUS) buttons as follows:
to
.
.
.
:
.