Roger Technology CTRL/P Instrucciones Y Advertencias Para El Instalador página 73

HW version
Year of manufacture
Week of manufacture
Serial number
FW version
View manoeuvre counter
The number consists of the values of the parameters from
N.B.: The values shown in the table are indicative only.
Manoeuvres performed
Example: x100 = 1,234,500 manoeuvres
View manoeuvre hour counter
The number consists of the values of the parameters from
are indicative only.
Manoeuvre hours
Example: = 123 hours
View control unit days on counter
The number consists of the values of the parameters from
N.B.: The values shown in the table are indicative only.
Days with unit switched on
Example: = 123 days
Password
Setting a password prevents unauthorised persons from accessing the settings.
With password protection active ( = ), parameters may be viewed but the values CANNOT be modified.
Only a single password is used to control access to the barrier automation system.
WARNING: Contact the Technical Support Service if you lose your password.
Password activation procedure:
• Enter the desired values for parameters
• Use the UP and/or DOWN
• Press and hold the + and - buttons for 4 seconds.
• The display flashes to confirm that the password has been saved.
• Switch the control unit off and on again. Check that password protection is activated (
Temporary unlock procedure:
• Enter the password.
• Check that = .
Password cancellation procedure:
• Enter the password ( =
• Save the values , ,
• Use the UP and/or DOWN
• Press and hold the + and - buttons for 4 seconds.
• The display flashes to confirm that the password has been cancelled (the values
and and indicate that no password is set).
• Switch the control unit off and on again.
Password change protection
Protection deactivated.
Protection activated.
, , and
buttons to view parameter
).
, =
buttons to view parameter
Example:
to multiplied by 100.
to . N.B.: The values shown in the table
to .
.
.
.
,
= ).
,
73