Roger Technology CTRL/P Instrucciones Y Advertencias Para El Instalador página 60

CONTACT
LOCKS
RECEIVER CARD
BATTERY CHARGER
B71/BCHP - BI/BCHP
BATTERY KIT
AG/BAT/KIT
BI/BAT/KIT
2x12 Vdc 4,5 Ah
ONLY AGM type
60
DESCRIPTION
(see fig. 10-11) Connectors for connecting lock device microswitch and safety stop micros-
witch on barrier inspection hatch (connection not supplied by ROGER TECHNOLOGY).
Jumper the other connector if only one connector is connected.
Connector for slot-in radio receiver board.
The controller has two radio remote control functions by default:
– PR1 - step mode command (modifiable with parameter
– PR2 - Closing command (modifiable with parameter
Connector for slot-in battery charger board.
In the event of a mains power loss, the controller unit is powered by the batteries. When
battery power is used, the message
flashes is activated with reduced frequency until mains power is restored or until the battery
voltage drops below the minimum permissible limit. In this case,
shown on the display and the controller unit accepts no commands.
If mains power is lost while the boom is moving, the boom stops and then automatically
resumes the interrupted manoeuvre after 2 seconds.
By setting parameter to a value different than
With parameter the battery operation limitation type is enabled when the voltage drops
under a certain threshold.
With parameter it is sets the type of operation limitation when the battery drops below
a certain threshold.
WARNING! the batteries must always be connected to the electronic controller unit in order
to charge. Periodically (at least every 6 months), check that the battery is in good working
order.
For more information, refer to the installation manual for the B71/BCHP - BI/BCHP
battery charger.
).
).
is shown on the display and the flashing light
, the battery management is enabled.
(Battery Low) is