Examples Of Applications In Parking Access Mode - Roger Technology CTRL/P Instrucciones Y Advertencias Para El Instalador

14

Examples of applications in parking access mode

The CTRL/P controller manages the system in parking access mode.
The function is enabled through the parameter
be used.
For this reason it is not possible to connect the ACS / BA / 60 system to these terminals.
N.B.: the input FT cannot be disabled in the following operating situations. If the contact (NC) is opened during a closing
manoeuvre, the barrier reopens and remains open until the contact is closed again.
The automatic closing time is enabled if parameter
vehicle to complete the crossing.
• Bi-directional mode with immediate closure (
When entering and leaving the parking area, the barrier is opened with an AP open command (terminal block).
Once the vehicle has crossed the barrier and released contact FT ((NC) (e.g. from magnetic loop), the barrier closes
immediately.
When parameter = , the barrier open and remains open until the vehicle has completed the passage. If the vehicle
moves back, the barrier remains open.
If parameter has a value different from
NOTE: it is possible to add further 5 s delay before closing, setting
• Directional mode 1 (
When entering the parking area, the barrier is opened with an AP open command (terminal block). Once the vehicle has
crossed the barrier and released contacts FT (NC) and PED (NO), the barrier closes. When leaving the parking area, the bar-
rier is opened by a PED command received from the magnetic loop.
Once the vehicle has crossed the barrier and released contact FT (NC), the barrier closes.
When parameter = , the barrier open and remains open until the vehicle has completed the passage. If the vehicle
moves back, the barrier remains open.
If parameter has a value different from
NOTE: it is possible to add further 5 s delay before closing, setting
PED
FT
AP
• Directional mode 2 (
When entering, the barrier is opened with an AP open command (terminal block), and closes after the automatic closing time
set with parameter .
NOTE: in order to have the automatic closing, to set parameter
When leaving the parking area, the barrier is opened by a PED (NO) command received from the magnetic loop. Once the
vehicle has crossed the barrier and released contact FT (NC), the barrier closes.
NOTE: it is possible to add further 5 s delay before closing, setting
PED
FT
AP
74
and ONLY the AP and/or PED command inputs at the terminal board must
is different to
, the barrier re-closes after an automatic re-closure set time.
FT
AP
)
, the barrier re-closes after an automatic re-closure set time.
PED
FT
)
different to
Tempo di chiusura
automa ca
Automa c closing
me
PED
FT
. Adjust an automatic closing time that allows the
)
.
FT
.
PED
FT
.
.
PED
FT
PED
FT
PED
FT