Travel Acquisition; Before Starting; Important - Roger Technology CTRL/P Instrucciones Y Advertencias Para El Instalador

11

Travel acquisition

For the system to function correctly, the barrier travel must be acquired by the controller.
11.1

Before starting:

IMPORTANT: Select the length of the boom with the parameter
It is very important that this parameter is selected correctly. An incorrect setting may cause severe
damage or injury.
SELECTION
AG/001PE
KB/001PE
BI/001PE
AG/001PC
KB/001PC
BI/001PC
1. Select the position of the barrier in relation to the gate, using parameter
barrier installed on the right (
If the installation position is changed from the right to the left, the position of the spring(s) must also
be changed.
For the correct installation, refer to the barrier installation manual.
IMPORTANT! Lubricate the pivot points with lithium based grease (EP LITIO)
2. Check that the "operator present" function is not enabled (
3. Check the spring balance setting and the mechanical stop settings.
For further information, refer to the installation manual of the barrier.
IMPORTANT! Lubricate the pivot points with lithium based grease (EP LITIO)
MODEL
) and the boom opening/closure gate on the left (seen from the inspection hatch side).
IMPOSTAZIONE
DI FABBRICA
FACTORY SETTING
>45°
45°
.
. The factory setting of the parameter is with the
OPEN CLOSE
).
<45°
BOOM
BA/68/3 up to 3 m
BA/60/3 up to 3 m
63