Acquisition Procedure - Roger Technology CTRL/P Instrucciones Y Advertencias Para El Instalador

4. If the ACS/BA/60 detachable boom coupling system is not installed, the parameter
5. Move the barrier boom into the completely CLOSED position.
6. Press TEST (see TEST mode in paragraph 9) and check the command signal and safety device states. If the safety devices
are not installed, jumper the contact or disable safety device function from the relative parameter (
TEST
CLOSED
1 click

ACQUISITION PROCEDURE:

PROG
AP P-
x4 s
AU to
OPENING
• Press and hold PROG for 4 seconds.
• Unlock the barrier, turning the key anticlockwise by two full turns. After a few seconds, the message
the display. The controller unit launches a calibration procedure. The operating parameters of the motor are determined
during calibration.
• If the motor calibration procedure is successful, the message
• To lock the barrier again, turn the key clockwise by two full turns. The acquisition procedure now starts.
• The message is shown on the display and the barrier starts opening at low speed.
• Once the barrier open mechanical stop is reached, the barrier stops briefly. The message
• The barrier closes until it reaches the barrier closed mechanical stop.
If the acquisition procedure is completed successfully, the display enters the command and safety device state display mode.
If the following error messages are shown on the display, repeat the acquisition procedure:
• : calibration procedure failed.
• . : acquisition error.
For more information, see chapter 16 "Alarms and faults".
64
TEST
No
1 click
TEST
No
1 click
Yes
TEST
1 click
UNLOCK
2x360°
45°
AU to
OPEN
is shown on the display.
must be set to
See chapters 15 and 16
Until ...
PROG
Press and hold...
ACQUISITION
PROCEDURE
PH A5
CLOSING CLOSED
flashes on the display.
.
, and ).
ACQUISITION
PROCEDURE
LOCK
2x360°
PH A5
Yes
is shown on
flashes on the display.