Final Installation - Harbor Breeze E-PAR52CB5C Manual Del Usuario

FINAL INSTALLATION (continued on next page)
1. Locate two canopy mounting screws (P) on underside of mounting
bracket (C) and remove canopy mounting screw (P) closest to the
open end of the hanging bracket (C). Partially loosen the other canopy
mounting screw (P). Lift canopy (B) to mounting bracket (C). Place
rounded part of slotted hole in canopy (B) over loosened canopy
mounting screw (P) in hanging bracket (C) and push up. Twist canopy
(B) to lock. Re-insert canopy mounting screw (P) that was removed,
and then tighten both canopy mounting screws (P) securely. Slide
canopy cover (Y) up to canopy (B), aligning rounded part of slotted
holes in canopy cover (Y) with screwheads in bottom of canopy (B).
Turn canopy cover (Y) to the right (clockwise) until it stops. [Fig. 1]
2. Position blade arm (H) under blade (J) and attach blade arm (H)
to blade (J) with blade screws (L) and blade washers (N). Do not
tighten blade screws (L) until each blade screw (L) has been
started. Then, tighten each blade screw (L) starting with the one in
the middle. [Fig. 2] Repeat for the remaining blades (J).
3. Insert only one motor screw (K), with lock washer (M), through
blade arm (H) to attach blade arm (H) to motor and partially tighten
motor screw (K). [Fig. 3] Repeat with remaining blade arms (H).
4. Insert remaining motor screws (K) along with lock washers (M).
[Fig. 4] Tighten all motor screws (K) securely.
5. Partially loosen two screws on fitter plate (on underside of
motor) and remove the other screw. Align slotted holes in switch
housing plate (F) with loosened screws in fitter plate, allowing male
plug from fan to come through hole in middle of switch housing
plate (F). Twist switch housing plate (F) to lock. Re-insert the
screw that was removed and securely tighten all three screws.
[Fig. 5]
6. Connect male plug from fan to female plug from switch housing
(E). Make sure that the plugs connect securely. [Fig. 6]
7. Remove three screws from switch housing plate (F). Align
holes in top of switch housing (E) with holes in switch housing
plate (F) and attach switch housing (E) with three screws that
were removed. Tighten all screws securely. [Fig. 7]
8. Remove socket rings (T) from sockets. Attach glass shades (I)
with these same socket rings (T). If necessary, use the socket ring
tool (W) to attach the socket rings (T) as shown. [Fig. 8]
Note: Do not overtighten socket rings (T) as glass may crack or
break.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Male
Plug
Fig. 5
Fig. 6
Fig. 7
Fig. 8
8
B
P
Y
A
L
N
J
H
D
J
M
H
K
D
H
J
D
Fitter Plate
F
D
F
Male Plug
Female
E
Plug
D
E
E
T
I
W