Mounting Sub-Modules (Shown For 16U Frame) - Eaton Pulsar Serie Manual De Instalación Y De Usuario

2.5

Mounting Sub-Modules (Shown for 16U Frame)

This operation must be carried out by qualified electrical personnel only. The battery can cause electric shock and high
short-circuit currents.
The following safety cautions are required before servicing the battery components:
Remove watches, rings, bracelets and all other metal objects from the hands and arms,
◗
Use tools with an insulated handle.
◗
6"
16U Frame shown
main
control
panel
module 4
module 3
module 2
module 1
1.
front panel
power sub-module
2.
battery sub-module
3.
front panel
4.
Modules must be mounted from the lowest level (module
1) to the highest level (module 4), installing the
power sub-module first and the battery sub-module
second. All the sub-modules must be mounted.
Follow steps 1 through 4 below to mount each of
the sub-modules.
1. Remove the 6 fixing screws to free the front panel
as shown.
2. Remove the mounting brackets from the power and
battery module slots. Insert the power sub-module
and attach the 4 mounting screws on each side of
the power sub-module.
Note: A red button will be depressed behind plate,
establishing connection.
3. Insert the battery sub-module and attach the 4
mounting screws on each side of the battery sub-
module.
4. Reattach the front panel.
Note: For removal of a sub-module, there is a safety
pin at the rear of the module. Slide the sub-
module out halfway, then lift slightly and the
sub-module will slide out.
Caution! The battery sub-module is heavy (approx.
60 lbs.).
To ensure safety and high performance, use only
batteries supplied by EATON.
86-87021-00 A01 - Page 17