First Use - Operating Burners; Lighting; Shutting Off Your Grill - Pit Boss PLATINUM KC COMBO PB1285KC Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Do not attempt to light another area of the burner. This can cause injury.
NOTE: Do not use spirit, lighter-fluid or kerosene for lighting or refreshing a fire in your grill.
4. Continue start-up by following steps four and five of Automatic Start-Up Procedure .
FIRST USE – OPERATING BURNERS
1.
Make sure all labels, packaging and protective films have been removed from the grill.
2. Remove manufacturing oils before cooking on this grill for the first time by operating the grill for at least 15 minutes on HIGH with
lid closed. This will "heat clean" the internal parts and dissipate odors.

LIGHTING

CAUTION: Keep outdoor gas cooking appliance area clear and free from combustible materials, gasoline and other
flammable vapors and liquids.
CAUTION: Do NOT obstruct the flow of combustion and ventilation air.
CAUTION: Check and clean burner/venturi tubes for insects and insect nests. A clogged tube can lead to a fire.
CAUTION: Attempting to light the burner with lid closed may cause and explosion.
1.
Open Lid.
2. Check for obstructions of airflow to the burners. Spiders, insects and webs can clog the
burner/venturi tube. A clogged burner tube can lead to a fire.
3.
All control knobs must be in the OFF position.
4. Connect LP gas tank per "Installing LP Gas Tank" section.
5.
Turn LP gas tank valve to OPEN.
6. Push and turn any control knob to HIGH. The burner should light. If it does not, repeat up
to three times.
7.
If ignition does not occur in 5 seconds, turn burner control knob OFF, wait 5 minutes, and
repeat lighting procedure.
8. If igniter does not light burner, use a lit match secured with the lighting rod (included with
the grill) to light burners. Access the burners through the cooking grid and heat plates.
Position lit match near side of burner (Fig. 3).
Important: Always use lighting rod (included) when lighting burners with a match.
9. After lighting, observe the burner flame. Make sure all burner ports are lit and flame
height matches illustration (Fig. 4).
NOTE: Each burner lights independently - repeat step 5-9 for other burners.
CAUTION: If burner flame goes out during operation, immediately turn the control knobs to the OFF position, LP
gas tank valved CLOSED, and open lid to let the gas clear for 5 minutes before re-lighting,

SHUTTING OFF YOUR GRILL

1.
LP: Turn LP gas tank valve to CLOSED.
2. Turn all control knobs clockwise to the OFF position.
NOTE: A "poof" sound is normal as the last of the LP gas is burned.
3.
Disconnect LP gas tank per Disconnect LP Gas Tank section.
WARNING: Allow the grill to cool completely, and remove the gas cylinder, before moving, travel, or for storage.
FIG. 3
FIG. 4
27

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido