Siemens SITRANS F FST020 IP65 NEMA 4X Instrucciones De Servicio página 23

Select Pipe Configuration
1. Press <Left Arrow> key and then <Down Arrow> key to select [Pipe Config].
2. Press <Right Arrow> key.
3. Press <Up/Down Arrow> keys to select a configuration that approximates the conditions
4. Press <ENTER> key to save selection. The [Anomaly Diams] menu will appear.
5. Press <Right Arrow> key twice. =
6. Press <Right Arrow> and then the <Up/Down Arrow> keys to select number of pipe
7. Press <ENTER> key to save selection.
FST020 IP65 NEMA 4X Quick Start
Operating Instructions, 08/2014, A5E03086489-AJ
upstream of your sensor mounting location. (Refer to the definitions below.)
①
Use this menu cell to select the pipe configuration that most accurately represents the
upstream pipe condition.
②
Use this menu cell to enter the number of pipe diameters between the upstream
configuration and the sensor installation.
diameters.
3.2 Programming the Transmitter
will appear.
Connecting
21