ARENDO 304971 Manual Del Usuario página 41

Select the "DIY" program using the dial. Press the "OK" button once
the Do-it-yourself menu is selected.
1. First select the degree of browning and confirm it using the
"ON" button.
2. You can then decide if you want to add any ingredients. Select
the tick mark in the "RAISING DISPENSER" field for "Yes" and the
cross mark for "No".
3. You can then delay the time step by step.
4. After this you can adjust the individual program steps. The time
symbol and the symbol for the current program step flash in the
display. The cycle is as follows:
KNEAD1-RAISE1-KNEAD2-RAISE2-BAKE-
KEEPWARM.
You can change the time of each program phase by turning the "+"
/ "-" dial. Press the "OK" button to confirm the time, and then move
onto the next phase. The next phase flashes on the display till all
the phases of the program are completed, press the "START/STOP"
button to confirm the settings and to exit the Setup.
If the current phase is confirmed, but you do not want to change
the idle period, you can also use the "START/STOP" button to con-
firm the current settings and exit the setup. If you press the "START/
STOP" button again, the program starts working as planned.
8. Selection of bread size and degree of browning
First select a program.
You can then select the degree of browning for the bread. Change
your settings using the "+" / "-" dial and confirm with the "OK"
button. You can choose between "LIGHT", "MEDIUM" and "DARK".
English
41