Stryker Formula Manual Del Usuario página 16

TPS Small Joint Shaver Handpiece
1. Push down on the locking collar (A) of the handpiece, as shown below.
A
2. Gently insert the shaver blade. A slight rotating motion will help properly
seat the blade.
3. Release the locking collar.
4. Pull the installed shaver blade slightly to ensure that it is engaged.
5. To remove a shaver blade, push down on the locking collar of the
handpiece and lift the shaver blade out of the handpiece.
Connecting Suction Tubing to the Handpiece
1. Connect a suction tube to the suction-tubing connector (A) on the
handpiece, as shown below. The tube should overlap all of the ridges on
the connector.
2. Gently tug on the suction tube to ensure it is firmly connected to the
handpiece.
3. Set the suction to the desired level.
EN-12
A