Stryker Formula Manual Del Usuario página 18

Selecting the Cutting Direction and Speed
Selecting any of the direction or cutting speed can be accomplished by using
the footswitch, handpieces, or console.
The handpieces offers three basic cutting directions:
• Forward
• Reverse
• Oscillate
In the forward and reverse directions, the handpiece also offers two preset
cutting speeds:
• High
• Low
For details on the footswitch, handpiece, or console control settings please
refer to appropriate console user guide.
Controlling the Handpiece
Footswitch Control
The handpieces can be controlled using the footswitch. Please refer to the
appropriate footswitch and/or console user guide for control settings.
Figure 3: Crossfire™ footswitch
Note: The footswitch pedals may be reprogrammed to better suit user
preferences. For details, see the appropriate console user guide.
EN-14