Job Menu; Job Management - Cebora 227.00 Manual De Instrucciones

6

JOB MENU.

6.1

Job management.

In this section is possible to save, modify, restore, copy or
cancel the Job programs.
These operations are not realizable from robot terminal
but only via the control panel.
From robot terminal select the Parameter selection inter-
nal mode or from main page of Fig. 4 press T8 (INT), to
make the control panel operative.
Press T9 (JOB) to enter the "Jobs" menu (L13 lit).
With T10 and T11 or M2 can slide the memory positions
(01, 02, 03, etc.) already occupied from a Job or free
(none).
Press T6 (EXIT) to exit the Jobs menu without saving any
changes.
Press T9 (OK) to "load" the job selected, so that it can be
used (L13 is lit to indicate the Job mode and job parame-
ters are not editable).
Press T8 (RCL) (recall) to "copy" the parameters of the
selected job in the current work page (L13 shuts off to
indicate the exit from Job mode).
The program parameters are changeable using the normal
editing process, T7 (PAR).
Accessed in this way to the Process Params page in which
with the navigation keys T10, T11, T12 and T13 the pa-
rameters and their values are chosen to be modified.
3.300.559/C
After making the changes, with T6 (MEM) you store the
changes and is offered the choice screen of the memory
location to save the new program.
With T10 or T11 you choose in which memory location to
save the program, then with T6 (SAVE) to confirm.
If this location is already occupied by a job, you are
prompted to confirm your choice; if so the existing job
will be overwritten.
Furthermore, with T6, T7, T8 and T9 function keys they
can perform the functions shown on D3.
T6
(SAVE) save the actual working point in the memory
location selected on D3;
T7 (DEL) cancels the Job selected on D3;
T8 (RCL) recall the Job selected on D3 to modify it;
T9 (COPY) copies the Job selected on D3 in a different
memory location.
To exit the "Jobs" menu press T13 key twice.
G
B
31