System Description; Welding System Composition; This Manual - Cebora 227.00 Manual De Instrucciones

2

SYSTEM DESCRIPTION.

2.1

Welding system composition.

The Cebora SOUND MIG ROBOT SPEED STAR Weld-
ing System is a multi-process system for synergic MIG/
MAG welding, developed for use in combination with a
Fig. 2.1
1 Power source - control panel cable.
2 Power source - wire feeder extension.
3 Power source - robot control cabinet cable.
4 Power source - robot interface or robot control cable
(supplied with interface).
5 Robot control cabinet.
6 Welding wire spool holder.
7 Torch.
8 Wire feeder unit.
10 Welding wire sheath.
21 Power source.
22 Cooling unit.
24 Power source control panel.
25 Robot interface.
26 Standard cable corresponding to the field bus in use.
The welding system equipments, robot interface (25) ex-
cluded, communicate between them via CAN bus (CAN1)
serial line; the power source (21) communicates with the
robot control via CAN bus (CAN2) serial line.
If the robot control has the CANopen DS401 commu-
nication line type, interface (25) and cable (26) are not
necessary. In such case the CANopen cable (4) must be
requested separately to Cebora and the serial line CAN2
must be enabled using the "Auxiliary CAN" function in
the "Settings" menu, par. 8.
3.300.559/C
welding robot arm on automated welding systems.
It comprises a power source, eventually equipped with
cooling unit, a wire feeder a control panel and, if neces-
sary, a robot interface (see Fig. 2.1).
2.2

This manual.

This Instructions Manual has been prepared in order to in-
struct the staff assigned to the installation, the operation
and the maintenance of the Cebora Welding System.
It must be conserved with care, in a famous place to the
several one interested, it has to be consulted every time
are doubts, employee for the replacement parts request and
will has to follow all the operating life of the machine.
This Instructions Manual refers exclusively to the control
panel (24) (art. 227.00) and recalls references to the instruc-
tions manuals of the welding system others equipments, that
therefore, if necessary, will have to be consulted.
To be exact, it is specific for the art. 319.80 and 320.80
power sources with firmware version 06 and later.
In combination with different power sources, it remains
valid, although with the differences in the functions and
in the menu pages navigation, due to the characteristics of
the power sources to which it is connected.
In this manual the function names and acronyms that re-
call them are written in the same language of the text that
describes them, as they appear on the control panel dis-
plays (e.g.: in the italian language manual, function names
and acronyms are in italian), while the figures that appear
in the manual describe the function names and acronyms
only in english.
G
B
23