Installation - Soehnle Body Balance Comfort F5 Instrucciones De Manejo

Installation

1. Place the scales level and on a firm
surface for all measurements.
Danger! Risk of slipping
if surface is wet.
2. The operator terminal may optionally be
held in the hand, placed on a table,
remain on the scales or be hung on the
wall. When fixing the magnetic wall brak-
ket to a solid, smooth, dry and dust- and
grease-free base it is sufficient for you to
put the wall bracket into the oval slot on
the back of the operator terminal. Then
remove the tape over the adhesive patch
and press the operator terminal to the
fixing position horizontally at eye level.
3. With tiles or a rough surface, no guarantee
can be given of the length of life of the
adhesion. You should therefore screw the
wall bracket in place.
To do this remove the cover from the mag-
netic wall bracket by inserting a fingernail
or a knifepoint under the slot and levering
off the cover.
Then drill 2 holes in the wall at a distance
of 2 cm horizontally from each other. The
drill size is dependent on whether you
need to use wall plugs. Then screw in and
press cover back in. Put the operator termi-
nal on the magnetic bracket.
1.
2.
2.
3.
3.
2x 2x
GB
21