Warranty Conditions; Emc Guidance - Medel Elite Manual Del Usuario

EN

13. WARRANTY CONDITIONS

• The device is covered by a 5-year warranty from date of purchase for any defects
in the design or in the material used.
• The warranty consists in the replacement and/or repair free of charge of originally
detective components.
• The warranty does not cover the accessories supplied with the equipment and those
parts subject to normal wear and tear.
• The equipment must be repaired by authorized technical service centres only.
• The equipment must be sent to the authorized technical service centre for repair
within 8 days after the defect is noticed.
• The transport costs for the equipment are at user's charge. Any repair out of the
warranty conditions are at user's charge.
• The warranty does not cover failures resulting from misuse, abuse of the product
or in case the damage is not due to manufacturer's liability (accidental fall, rough
transportation, etc...)
• The warranty does not involve any compensation for any kind of damages to per-
sons or things, either direct or indirect, occurred when the equipment is not ope-
rating.
• The warranty is valid from the date of purchase certified by the ticket or the invoice
which have to be peremptorily attached to the warranty coupon.
• The lack of warranty coupon properly filled in and validated by a certification of
purchase voids the warranty.
COUPON TO BE RETURNED IN CASE OF REPAIRS
THE WARRANTY IS VALID ONLY IF ACCOMPANIED BY THE TICKET/INVOICE
Product type:
Model:
Serial No.:
Date of purchase:
BUYER'S DATA
Name:
Address:
Telephone:
Defect description:
Signature for acceptance of the above mentioned warranty conditions
41
100114_MEDEL ELITE USER MANUAL_REV.00_FEB.2017.indd 41-42

EMC GUIDANCE

1. This product needs special precautions regarding EMC and needs to be installed
and put into service according to the EMC information provided, and this unit can
be affected by portable and mobile RF communications equipment.
2. * Do not use a mobile phone or other devices that emit electromagnetic fields, near
the unit. This may result in incorrect operation of the unit.
3. Caution: This unit has been thoroughly tested and inspected to assure proper per-
formance and operation!
4. * Caution: this machine should not be used adjacent to or stacked with other
equipment and that if adjacent or stacked use is necessary, this machine should be
observed to verify normal operation in the configuration in which it will be used.
Table 1) Guidance and MANUFACTURER's declaration
ELECTROMAGNETIC EMISSIONS- for all ME EQUIPMENT and ME SYSTEMS
Guidance and manufacturer's declaration – electromagnetic emissions
The device is intended for use in the electromagnetic environment specified below. The customer
or the user of the device should assure that it is used in such an environment
Emissions test Compliance
RF emissions
Group 1
CISPR 11
RF emissions
Class B
CISPR 11
Harmonic emissions
Class A
IEC 61000-3-2
Voltage fluctuations/
flicker emissions IEC Complies
61000-3-3
EN
Electromagnetic environment - gui-
dance
The device uses RF energy only for
its internal function. Therefore, its RF
emissions are very low and are not
likely to cause any interference in
nearby electronic equipment.
The device is suitable for use in all
establishments, including domestic
establishments and those directly
connected to the public low-voltage
power supply network that supplies
buildings used for domestic
purposes.
42
10/02/2017 19:03:00